7
VQT2G22
∫ Detaching the Lens
≥ Check that the camera is turned off.
Press the lens release
button C while turning
the lens as far as
possible in the direction
of the arrow to detach it.
• Attach the lens rear cap so
that the lens contact point does not get
scratched.
• Attach the body cap to the camera so no dirt or
dust will get inside the main unit.
∫ Attaching and Detaching the Lens Cap
≥ Be careful not to lose
the lens cap.
∫ Attaching Filters
≥ Vignetting may occur if using 2 or more
MC protectors (optional:DMW-LMC46),
PL filters (optional:DMW-LPL46) or ND filters
(optional:DMW-LND46), or if using thick
protectors and/or filters.
≥ The filter may become impossible to remove if
excessively tightened, so please refrain from
tightening it too strongly.
≥ It is possible to attach the lens cap with the filter
already attached.
≥ If you have problems with the attachment or
removal of the PL filter (optional:DMW-LPL46), we
recommend turning on the digital camera and
trying again with the focus mode set to “manual”
([MF]).
≥ Accessories other than filters, such as conversion
lenses or adaptors, cannot be mounted on this
lens. It may interfere with the focus operation or
damage the lens.
To Next Page
Loading...
