No.SX-DSV01676 - 44 -
R2 Motor Company, Matsushita Electric Industrial Co., Ltd.
12-3 Servo drive and list of applicable peripheral equipments
Servo
drive
motor
Voltage
Spec.
Rated
output
Circuit
Breaker
(Rated
current)
Noise
filter
Surge
absorber
Noise filter
for signal
line
Electromagnetic
contactor
Main
circuit cable
diameter
Control
Power
Cable
diameter
Teminals
on the
feminalblock
100V, single-
phase
50W～
100W
BMFT61041N
(3P+1a)
0.75～2.0mm2
0.75mm2
MADD MSMD
200V, single-
phase
50W～
200W
10A DV0P4170
DV0P4190
BMFT61541N
(3P+1a)
AWG14～18
AWG18
100V, single-
phase
200W
BMFT61041N
(3P+1a)
Connect to the
exclusive
connectors.
MBDD MSMD
200V, single-
phase
400W
BMFT61541N
(3P+1a)
MSMD
100V, single-
phase
400W DV0P4180
BMFT61541N
(3P+1a)
MCDD
MSMD
200V, single-
phase/3 phase
750W 15A
BMFT61042N
(3P+1a)
MDMA 1kW DV0P4220
MDDD
MDMA
200V, single-
phase/3 phase
1.5kW 20A
BMFT61042N
(3P+1a)
2.0mm2
AWG14
MDMA 2.5kW
2.0mm2
AWG14
MEDD
MDMA
200V, 3 phase
3.0kW
30A
BM6352N
(3P+2a2b)
3.5mm2
MFDD MDMA 200V, 3 phase 5.0kW 50A
DV0P3410
DV0P4150
DV0P1460
BM6652N
(3P+2a2b)
5.3mm2
AWG10
M5
*Select the single/3-phase common drive based on the power supply to be used.
● Manufacturer of circuit breaker and magnetic contactor: Matsushita Electric Works, Ltd.
Connect a circuit breaker which conforms to IEC Standard and is UL recognized (UL Listed and marked) between
the power supply and the noise filter without fail in order to make the machine conform to EC Directives.
● For details of noise filter, refer to section 12-2-4.
<Remarks>
●Select the circuit breaker and noise filter matching to the power capacity (including the load condition).
●Terminal block and earth terminal
Use a cable of copper conductor with temperature rating of 60degrees or higher.
Protective earth terminal is M4 for A to D-frame.
Use an earth cable with diameter of 2.0mm2 (AWG14) or larger for 50W to 1.5kW
●For A to D-frame, use the attached exclusive connector and keep the peel-off length of 8 to 9mm.
To Next Page
Loading...
