EasyManua.ls Logo

Panasonic MINAS A5 Series - Page 80

Panasonic MINAS A5 Series
477 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-32
:LULQJRI0DLQ&RQQHFWRU;$
&LUFXLW%UHDNHU0&&%
To protect power supply line from overload-
ing, install a wiring circuit breaker rated to
the capacity of the power supply.
1RLVH)LOWHU1)
Removes external noise from the power
lines. And reduces an effect of the noise
generated by the servo driver.
0DJQHWLF&RQWDFWRU0&
Turns on/off the main power of the servo
driver.
Use coil surge suppression units together
with this.
1HYHUVWDUWQRUVWRSWKHVHUYRPRWRU
ZLWKWKLV0DJQHWLF&RQWDFWRU
5HDFWRU/ (to be supplied by customer)
Reduces harmonic current of the main
power.
$SSO\WKHYROWDJHGHVLJQDWHGRQWKHQDPHSODWH
from the power source.
Symmetric current should be 5000 Arms or below.
If the short-circuit current on the power source
exceeds this value, use a current-limiting device
(e.g. current-limiting fuse, current-limiting circuit
breaker or transformer).
5HJHQHUDWLYHUHVLVWRU(optional)
:KHQ\RXXVHDQH[WHUQDOUHJHQHUDWLYHUHVLVWRU
LQVWDOODQH[WHUQDOSURWHFWLYHDSSDUDWXVVXFK
DVWKHUPDOIXVHZLWKRXWIDLO
7KHUPDOIXVHDQGWKHUPRVWDWDUHEXLOWLQWRWKH
regenerative resistor (Option). ,IWKHWKHUPDOIXVH
LVDFWLYDWHGLWZLOOQRWUHVXPH
0RXQWWKHUHJHQHUDWLYHUHVLVWRURQLQFRPEXVWLEOH
PDWHULDOVXFKDVPHWDO
5HPDUNV
:LULQJRI0RWRU&RQQHFWRU;&
3LQ%SLQ%SLQDQG%SLQ
%DQG%WREHNHSWVKRUWHGIRUQRUPDO
RSHUDWLRQ
:KHQ\RXFRQQHFWDQH[WHUQDOUHJHQHUDWLYH
resistor, disconnect a short circuit wire
between B2 and B3, then connect the external
regenerative resistor between B1 and B2, set
up Pr0.16 to 1 or 2.
&RQQHFWLRQWRLQSXWSRZHU
:LULQJWR&RQQHFWRU;$ P. 2 -3 4
&RQQHFWLRQWRcontrol power
:LULQJWR&RQQHFWRU;' P. 2 -3 4
&RQQHFWLRQWRH[WHUQDOFRPSRQHQWV
:LULQJWR&RQQHFWRU;& P.2-34
L3 (Pin-1)
L2 (Pin-2)
L1 (Pin-3)
0V
24V
* Use a power
supply with
2 A or larger
capacity.
B1 (Pin-4)
B2 (Pin-2)
9'&SRZHUVXSSO\
IRUFRQWURO
(to be supplied by customer)
0DLQV
Residual
current device
Connecting Example of D, E-frame
2
Preparation
2.
6\VWHP&RQÀJXUDWLRQDQG:LULQJ
Overall Wiring (D, E-frame, 400 V type)
Note
Related page
7KLVRYHUDOOZLULQJGLDJUDPLVDW\SLFDORQH7KHSDJHVWKDWIROORZVKRZZLULQJIRUVSHFLÀF
application. The wiring indicated with the broken line shall be provided only when required.
3´2SWLRQVµ
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

Table of Contents

Related product manuals