Panasonic MINAS A5 Series - Page 92

2-44
:LULQJRI0DLQ&LUFXLW
&LUFXLW%UHDNHU0&&%
To protect power supply line from overloading,
install a wiring circuit breaker rated to the capacity
of the power supply.
1RLVH)LOWHU1)
Removes external noise from the power lines. And
reduces an effect of the noise generated by the
servo driver.
0DJQHWLF&RQWDFWRU0&
Turns on/off the main power of the servo driver.
Use coil surge suppression units together with this.
1HYHUVWDUWQRUVWRSWKHVHUYRPRWRUZLWKWKLV
0DJQHWLF&RQWDFWRU
5HDFWRU/ (to be supplied by customer)
Reduces harmonic current of the main power.
$SSO\WKHYROWDJHGHVLJQDWHGRQWKHQDPH-
plate from the power source.
Symmetric current should be 5000 Arms or below.
If the short-circuit current on the power source
exceeds this value, use a current-limiting device
(e.g. current-limiting fuse, current-limiting circuit
breaker or transformer).
5HJHQHUDWLYHUHVLVWRU
(optional)
:KHQ\RXXVHDQH[WHUQDOUHJHQHUDWLYH
resistor, LQVWDOODQH[WHUQDOSURWHFWLYH
DSSDUDWXVVXFKDVWKHUPDOIXVHZLWKRXW
IDLO.
7KHUPDOIXVHDQGWKHUPRVWDWDUHEXLOWLQWRWKH
regenerative resistor (Option). ,IWKHWKHUPDO
IXVHLVDFWLYDWHGLWZLOOQRWUHVXPH
0RXQWWKHUHJHQHUDWLYHUHVLVWRURQ
LQFRPEXVWLEOHPDWHULDOVXFKDVPHWDO.
)RUZLULQJRIWKHFLUFXLWUHIHUWR´:LULQJ
Diagram” on P.2-47.
5HPDUNV
&RQQHFWLRQZLWKLQSXW
SRZHUVXSSO\
P. 2- 46
Charge lamp (LED)
Do not make displacement,
wiring or inspection while
the LED is lit - cause of
electric shock.
24V0V
Neutral point
L1C
B1
B2
L1 L2 L3
0DJQHWLF&RQWDFWRU0&
:KHQ\RXXVHDQH[WHUQDOG\QDPLFEUDNHUHVLVWRULQVWDOODQ
H[WHUQDOSURWHFWLYHDSSDUDWXVVXFKDVWKHUPDOIXVH
ZLWKRXWIDLO
0RXQWWKHG\QDPLFEUDNHUHVLVWRURQLQFRPEXVWLEOHPDWHULDO
VXFKDVPHWDO
)RUZLULQJRIWKHFLUFXLWUHIHUWR´:LULQJ'LDJUDPµRQ3
)RUDQH[DPSOHRIWKHUHFRPPHQGHGSURWHFWLYHFLUFXLWUHIHUWR
“Dynamic Brake” on P.2-67.
'\QDPLF%UDNH
UHVLVWRU
to be supplied by
(
customer
)
Turns on/off the dynamic brake
resistor.
Use coil surge suppression units
together with this.
5HPDUNV
9'&
SRZHUVXSSO\IRU
UHJHQHUDWLYHUHVLVWRU
to be supplied by
(
customer
)
* Use a power
supply with
5 A or larger
capacity.
&RQQHFWLRQWRH[WHUQDO
FRPSRQHQWV
P.2-46
Mains
Residual
current device
* Use a power
supply with
5 A or larger
capacity.
9'&SRZHUVXSSO\
IRUFRQWURO
(to be supplied by customer)
&RQQHFWLRQZLWK
FRQWUROSRZHU
VXSSO\
P.2-46
Connecting Example of H-frame
2
Preparation
2. 6\VWHP&RQÀJXUDWLRQDQG:LULQJ
Overall Wiring (H-frame, 400 V type)
Note
Related page
7KLVRYHUDOOZLULQJGLDJUDPLVDW\SLFDORQH7KHSDJHVWKDWIROORZVKRZZLULQJIRUVSHFLÀF
application. The wiring indicated with the broken line shall be provided only when required.
3´2SWLRQVµ
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com