2-90
14. How to Use the Front Panel
Monitor Mode (EXECUTION display)
(11) Display of No. of changes in I/O signals
(12) Display of absolute encoder data
• Shift the flashing decimal point with .
.....Input signal
.....Output signal
Pin No.
No. of changes in I/O signals (the signal is invalid)
• Select the No. of pin, the number of changes on that pin should be displayed,
by pressing or button.
• The switch of input/output, by pressing or button.
(Left side of decimal point : Pin No. selection)
(Right side of decimal point : Input/Output Pin No. selection)
(Lowest place Pin No.
of output signal)
(Highest place Pin No.
of input signal)
Encoder data
......One revolution data, Low order (L)
• Select the data to be displayed by pressing or button.
......One revolution data, High order (H)
......Multi-revolution data
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
