Panasonic MINAS A6 Series - Page 231

4-29
1
Before Using the Products
2
Preparation
3
Connection
4
Setup
5
Adjustment
6
When in Trouble
7
Supplement
Note
Related page
•Aparameterisdesignatedasfollows:
Pr0.00
Parameter No.Class
•ForparameterswhichNo.haveasuffixof“
*
”,changedcontentswillbevalidated
whenyouturnonthecontrolpower.
•P.3-32...“InputsandoutputsonconnectorX4”
Default: [ ]
Pr2.24
5th notch frequency
Range Unit Default
Related
control mode
50 to 5000 Hz 5000 P S T F
Caution
Setthecenterfrequencyofthe5thnotchlter.
Thenotchlterfunctionwillbeinvalidatedbysettingupthisparameterto"5000".
Pr2.25
5thnotchwidthselection
Range Unit Default
Related
control mode
0 to 20 — 2 P S T F
Caution
Setthewidthofnotchatthecenterfrequencyofthe5thnotchlter.
Higherthesetup,largerthenotchwidthyoucanobtain.Usewithdefaultsetupinnormal
operation.
Pr2.26
5th notch depth selection
Range Unit Default
Related
control mode
0 to 99 — 0 P S T F
Caution
Setthedepthofnotchatthecenterfrequencyofthe5thnotchlter.
Higherthesetup,shallowerthenotchdepthandsmallerthephasedelayyoucanobtain.
Pr2.27
1stvibrationcontrolwidthsetting
Range Unit Default
Related
control mode
0 to 1000 — 0 P F
Toconductnetuningof1stvibrationsuppressioncontrolfunction.
Pr2.28
2ndvibrationcontrolwidthsetting
Range Unit Default
Related
control mode
0 to 1000 — 0 P F
Toconductnetuningof2ndvibrationsuppressioncontrolfunction.
Pr2.29
3rdvibrationcontrolwidthsetting
Range Unit Default
Related
control mode
0 to 1000 — 0 P F
Toconductnetuningof3rdvibrationsuppressioncontrolfunction.
Pr2.30
4thvibrationcontrolwidthsetting
Range Unit Default
Related
control mode
0 to 1000 — 0 P F
Toconductnetuningof4thvibrationsuppressioncontrolfunction.
1. Details of parameter
[Class 2] Damping control
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com