Panasonic NA-148XR1 - Troubleshooting; Appliance Issues Resolution; Wash Process Issues Resolution; Error Display Code Solutions

32 3333
Troubleshooting
Problem Cause and Measures
Appliance
Buttons do not
work
- Settings cannot be changed while an operation is in
progress. Only the spin speed, “Extra Rinse” and “Easy
Iron” settings can be changed when the wash process
is paused.
- The Child Lock (
) may be activated. (P. 28)
Door does not
open
- The door is locked while an operation is in progress.
(P. 14)
- The Child Lock (
) may be activated. (P. 28)
- The temperature inside the drum may be very high.
- The water level may be too high.
■ To open the door immediately
(1) Switch the appliance off and then on again.
(P. 10)
(2) Select the “Cotton” programme.
(3) Select
in “Mode” (P. 26), and start operation.
- If you switch off the appliance or there is a power cut
while the door is locked, it remains locked until the
power is turned on again.
Unusual odour
- Rubber parts may give off a smell when you rst use
the appliance, but the smell will go away over time.
- Run a wash at 60 °C to clean the drum. (P. 30)
Wash
No water going
into the appliance
- The tap may be turned off.
- The water supply may be disrupted.
- The water supply hose may be frozen. (P. 29)
- The water supply lter may be blocked. (P. 29)
Water builds up
during a wash
- This is normal. Water is automatically supplied if the
water level falls.
Water drains out
during a wash
- If there is excess foam, water is drained out and fresh
water supplied to remove the foam. This is the foam
detection function.
- Even if water is directly supplied to the drum, it may
drain away without building up.
Water supply
stops and water is
drained away
- The water supply is automatically stopped if the water
volume in the drum reaches a certain level, and some
water may drain away. This feature is called the
overow detection function.
Troubleshooting Opening the Door in an Emergency
When the door stays locked due to
a power failure, or while displaying
an error that starts with “H”, the door
can be opened using the following
instructions.
1 Turn off the power, and open the
drain lter cover. (P. 31)
2 When there is water in the drum,
drain the water by removing the
drain lter. (P. 31)
3 Pull down the emergency door
unlock tab.
The door lock is released, and you
can open the door.
Emergency
door unlock tab
CAUTION
zThere is a risk of burns during
operation at high temperatures.
- Operate after temperature has
fallen.
zThere is a risk of injury if you put
your hand in the drum during
rotation.
- Operate after the rotation has
stopped.
zOpening the door when water
can be seen through the glass of
the door may cause the water to
spill.
- Drain the water by removing the
drain lter. (P. 31)