36 3737
TroubleshootingInstallation
Service person only
Error Display
Unable to drain
What to do
Check the drain hose for any of following problems:
- It is blocked with debris.
- Hose tip is immersed in water.
- It extends further than 3 m.
- Water in the pipe is frozen.
Clean the drain lter if blocked. (P. 31)
After correcting the problem, open the door then close it, then
press the start button to restart the machine.
Door is open
What to do
Make sure that door is closed properly.
Close the door securely and press the start button.
Unable to spin-dry
The product has been designed to detect unbalanced loads,
particularly small loads, in order to ensure quiet operation and
achieve the best results.
This is not a malfunction. Perform any of the following solutions.
What to do
- Please try to untangle clumps of clothing.
- If you wash large items, e.g. blankets, please reduce the load.
- In case of very small load, add one or two bath towels.
- Please check that your product is on a stable surface.
- Please adjust the feet to ensure the machine is level.
After correcting the problem, open the door then close it, then
press the start button to restart the machine.
Unable to supply
water
What to do
Check for any of following problems:
- Supply tap is closed.
- Water pipe or hose is frozen.
- Water supply has been disrupted.
- Water supply lter is blocked. (P. 29)
After correcting the problem, open the door then close it, then
press the start button to restart the machine.
If the red mark appears in the hose with a water supply valve,
the water supply has stopped.
Replace with a new hose.
Hose with water supply valve (No. AXW-598865)
An error starting with “H” is displayed.
What to do
Press the Off button. If the display stays on, or if the error
message appears again when you press the Start button, unplug
the machine and contact your local Customer Service Centre.
Choosing the Right Location
z Make sure to ask a service person for installation. Do not install by yourself.
z If the installation, test run and inspection of the washing machine are not
carried out following this installation method, Panasonic will not be liable for
any accident or damage caused.
Appliance dimensions
(d)
(e)
(c)
(a)
(b)
Locations the appliance is not to
be installed
- In a damp place or where the
appliance may be exposed to rain,
etc. (As this could cause electric
shock or re)
- Locations that are uneven, or
unstable (As this could cause
vibration and noise)
- In direct sunlight (As this
could cause a malfunction or
deformation)
CAUTION
Do not install where temperatures
may reach freezing.
Set-in installation
- Install the appliance with easy
access to the mains plug and
socket.
- Install the appliance where there is
enough space around it.
(a): 3 mm or more above
(b): 3 mm or more behind
(c): 2 mm or more on the left side
(d): 2 mm or more on the right side
(e): 60 cm or more
To Next Page
Loading...
