Panasonic NA-148XR1 - Connecting the Hoses; Water Supply Hose Connection; Drain Hose Connection Options

40 4141
Installation
Service person only
Connecting the Hoses
Connect the hoses properly to prevent water leaks.
 Maximum connection distance of hoses and mains lead
Water supply hose
 Mains water pressure and water ow
zWater pressure: 0.03-1.0 MPa
If the water pressure exceeds this
value, t a pressure reducing valve.
zWater ow from tap: 5 L/min. or
more

Connecting the water supply hose
CAUTION
zDo NOT twist, squash, modify or
cut the hose.
zTighten the nut rmly.
1 Attach one end of the hose to the
water inlet on the appliance and
tighten by hand.
Water inlet
Water supply
hose
(Rear of appliance)
2 Attach the other end of the hose to
the tap and tighten by hand.
min.
10 mm
3/4"
Hose with water
supply valve
Standard hose
3 Turn on the tap slowly and make
sure there are no leaks.
Drain hose
 Draining to a sink or wash basin
CAUTION
Secure the drain hose with an elbow
so that it does not come off by water
pressure during drainage.
Elbow
(supplied)
 Draining to a stand pipe
Stand pipe
 Draining to a drain hole
NOTE
zDo not twist, pull out or bend the
drain hose.
zDo not put the hose tip under water.
Left side connections
Right side connections
Sink
Water supply hose
Water supply hose
Drain hose
Drain hole
145 cm
95 cm
85 cm
p
q
Rise of drain hose
(max. 100 cm)
Drain hole
95 cm
140 cm
40 cm
Sink
p
q
Rise of drain hose
(max. 100 cm)
Drain hose