6.6. Door assembly
1. Open the door and remove door C from door E by carefully
pulling outward starting from upper right hand corner.
2. Remove door key and door key spring.
3. Remove 2 screws holding side frame of door A.
4. Seperate the door A from the door E by freeing catch hooks
on the door A using a flat screwdriver.
After replacement of the defective component parts of
the door, reassemble it and follow the instructions
below for proper installation and adjustment so as to
prevent an excessive microwave leakage.
5. When mounting the door to the oven, be sure to adjust the
door parallel to the bottom line of the oven face plate by
moving the upper hinge and lower hinge in the direction
necessary for proper alignment.
6. Adjust so that the door has no play between the inner door
surface and oven front surface. If the door assembly is not
mounted properly, microwave power may leak from the
clearance between the door and oven.
NOTE:
Door alignment is crucial. If door is misaligned, apply
pressure until alignment is achieved.
NOTE:
After replacement of the defective component parts of
the door, reassemble, and perform microwave leakage
test.
6.7. Temp sensor (thermal
protector) (NE-1037)
1. Cut a lead wire at the top of sensor terminals.
2. Remove 1 screw holding the temp sensor and replace with
new one.
3. Solder the lead wires securely to the sensor terminals.
6.8. Floor shelf and/or moving
antenna
1. Insert a phillips type screwdriver or equivalent approx. 2"
(5 cm) in shaft length in the access hole in the left side oven
wall as shown in Figure.
2. Carefully lift up the floor shelf by prying up with the
screwdriver until the floor shelf is lifted up over the level of
oven front opening.
3. Remove the floor shelf by lifting it out through the oven
front.
To replace moving antenna.
4. Remove the moving antenna by simply lifting it up off the
stirrer motor shaft.
NOTE:
When replacing the moving antenna, make sure the
plastic stirrer spacers are correctly in place. They
are necessary to stabilize the antenna by gliding
around the oven bottom as the antenna turns.
16
NE-1027 / NE-1037
To Next Page
Loading...
