– 19 –
How to Operate
X 2 or 3 stages heating
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see page 20)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
Example: To program cooking at DEFROST power for 1 minute and at HIGH power for 2 minutes into
Memory pad “5”
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
Follow steps 1 to 5 on page 18.
1
A
PROG
6
Press Power Level Selector pad once.
The power level for 2nd stage will be indicated, 2nd Stage Heating
Indicator “2” will start to blink.
1
A
2
PROG
7
Set the desired heating time using Timer Dial.
The set heating time will appear.
Note: up to 15 min. on or , 60 min. on , or
1
A
2
PROG
8
PROG
Press Program Entry Switch again.
“PROG” and 2nd Stage Heating Indicator “2” will stop blinking. The
total time for both stages will appear. This means that you have
completed programming.
1
A
2
PROG
• Three seconds later, Digital Display Window will go blank.
To Next Page
Loading...
