– 26 –
Self Diagnostics Failure Code Explanation
Technical Specifications
This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODE CAUSE WHAT TO DO
F01 • Overcooked food.
• Temperature of exhaust air too high.
• Disconnect appliance from electricity supply to stop
beep.
• Wait for appliance to cool down to reset operation.
• If food ignites, do not open the door.
• If normal operation does not resume, call the service
agent with information of failure code.
F05 • Defective Memory IC. • Disconnect appliance from electricity supply and wait
more than 1 minute and reconnect.
• If normal operation does not resume, call the service
agent with information of failure code.
F33–34 • Defective thermistor circuit.
F44 • Defective control panel.
F81–F84
F86–F89
• Defective relay circuit.
Note: Above codes shown in the display do not indicate all the possible failures on the unit.
NE-3280 NE-1880
Power Source 230 - 240 V, 50 Hz, single phase
Required Power 5220 W/22.3 A 3400 W/14.8 A
Output
HI 3200 W*
MED 1600W
LOW 340 W
DEF 170 W
STAND 0 W
HI 1800 W*
MED 900 W
LOW 340 W
DEF 170 W
STAND 0 W
Frequency 2450 MHz
Outer Dimensions (W x D x H) 650 mm x 526 mm x 471 mm
(25
9
⁄16” x 20
3
⁄4” x 18
9
⁄16”)
Cavity Dimensions (W x D x H) 535 mm x 330 mm x 250 mm
(21
1
⁄16” x 13” x 9
7
⁄8”)
Net Weight 65 kg 54 kg
Timer Maximum programable time for single stage heating
and = 15 min.
, and = 60 min.
Memory Capability 16 programs
*IEC Test Procedure
Specifications subject to change without notice.
650 mm
471 mm
630 mm
10 mm
10 mm
55 mm
526 mm
501 mm
455 mm
25 mm
850 mm
480 mm
Front View Side View Side View with Opened Door
To Next Page
Loading...
