Panasonic NI-552R - Page 6

NOTE: 3 position steam button.
fan fi
© fh
Dry Low steam High steam
(Button UP: for High steam. MED: for Low steam)
Now steam ironing can begin
6. Anytime the iron is set vertically the steaming action will stop.
NOTE: Do not use the steam buiton unless the iron is sufficiently hot enough to produce steam,
otherwise water will leak out through the vents instead.
HOW TO USE AS A DRY IRON
1. Press the steam button down to the dry position.
2. Place the iron vertically, set the selector dial to OFF.
3. Plug in the iron.
4. Set the temperature selector dial to the desired position.
(Refer to the Fabric Ironing Chart in this manual on page 10)
5. Preheat the iron until the indicator light goes out, usually about 1-2 minutes.
HOW TO USE THE SPRAY FEATURE
Before using the spray feature, check the garment label for
ironing instructions because some fabrics may spot or stain
with moisture.
The spray feature is particularly helpful for removing
stubborn wrinkles and where extra dampening is needed.
The spray may be used with steam or dry ironing.
1. Simply pump the spray button when spray Lb pT
$ : í PAA
is desired. If the spray doesn't work DALA
immediately just keep pumping till it does. E (This picture is m
2. To get a finer spray, pump the button vigorously. To get coarser spray, pump the button
more slowly. For best results, use a quick, full stroke.
-6-