Panasonic NI-E200T - How to Use as a Dry Iron; How to Use the Spray Feature

NOTE: 3 Position Steam/Dry Selector .
Dry | Low steam | High steam
(Right : for High Steam, Center: for Low Steam )
Temperature Zone | Steam/Dry Selector Position
=
F Ale
Low steam sore CT
A Zone PACE
R me High steam
: 03
Now steam ironing can begin
7. Whenever the iron is positioned vertically, the RE l Û
steaming action will stop.
A
CAUTION
Do not use the Steam/Dry Selector unless the iron is sufficiently hot to produce steam,
otherwise water will leak out through the vents instead.
HOW TO USE AS A DRY IRON
1. Move the Steam/Dry Selector to the Dry position.
2. Position the iron vertically, set the Temperature Selector Dial to “Off”.
3. Plug in the iron.
4. Set the Temperature Selector Dial to the desired position.
(Refer to the FABRIC IRONING CHART in this manual on page 12 )
5. Preheat the iron until the Indicator Light goes out, usually about 1-2 minutes.
HOW TO USE THE "SPRAY" FEATURE
Note: Before using the spray feature, check the fabric label for ironing instructions because
some fabrics may be spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra
dampening is needed.
The spray may be used with steam or dry ironing.
= 7 =