Panasonic NI-E200T - How to Use the Vertical Steam Feature; Maintenance and Safety Features; Self-Cleaning Procedure

HOW TO USE THE "VERTICAL STEAM" FEATURE (NI-E650TR/E655TR Only)
To get better results when using vertical steam, hang
the garment on a clothes hanger. Curtains and drapes
may also be steamed once they're hung. Hold the iron
away from your body, close to but not touching the fabric.
Pull the fabric tight with your free hand and pump the
Vertical Steam Button (Jet of Steam Button) at 2-5 seconds
intervals as you pass the iron over the wrinkled fabric.
A
WARNING
= Never iron clothes on the body or point your iron at anyone when steaming.
= Keep hands and body away from steam areas while using vertical steam feature.
SELF-CLEANING (NI-E650TR/E655TR/E300TR Only)
With the self-cleaning feature you can flush out mineral residue from the steam generating
chamber and the steam vents, refreshing your iron each time for a longer steaming life.
It is very important to operate the self-cleaning feature after each steam ironing to prevent
mineral accumulations from hardening.
1. Check water level. Water level should be at 1/2 full mark.
When water level is less than half full, fill with water according
to the instructions in “HOW TO FILL WITH WATER ”.
2. Preheat at “ Max ” setting (for about 1-2 minutes).
Make sure that the Steam/Dry Selector is in the Dry position.
3. Set the Dial to “Off” and remove the AC plug.
. Hold the iron horizontally over the sink.
5. Pump the "Jet of Steam Button " quickly (at least 3
times per second) about 20-30 times.
6. While self-cleaning, tilt the iron up and down slowly to help clean
the entire inside and let the water drip out of the soleplate vents.
7. Check that all water and steam have completely stopped coming out of the soleplate
vents. After self-cleaning is finished, empty any remaining water from the Water
Reservoir by turning the iron upside down.
8. Iron on a towel to remove any drops of water remaining on the bottom of iron.
9. Allow the iron to cool and store on its Heel Rest. Never store an iron on its Soleplate or
with water in it.
10. If water still remains inside the Soleplate after self-cleaning operation, dry out the iron
by setting the iron on the “Max” setting, to vaporize the remaining water. After the iron is
dry, follow the instructions under " AFTER EACH USE".
-9-
D