English
- En-15 -
Before Requesting Service
ALL THESE THINGS ARE NORMAL:
Oven will not turn on.
PROBLEM
POSSIBLE CAUSE REMEDY
Oven will not start cooking.
The words “DEMO MODE”*
appear on the screen.
When the oven is turning on,
there is noise coming from
Ceramic Tray.
* DEMO MODE is designed for retail store display.
Cooking and other functions will not operate during demo mode.
If it seems there is a problem with the oven, contact an authorized Service Center.
The oven causes
interference with my TV.
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused by
small appliances such as mixers, vacuums, hair dryers, etc. It does not
indicate a problem with your oven.
Steam accumulates on the
oven door and warm air
comes from the oven vents.
During cooking, steam and warm air are given off from the food. Most of the
steam and warm air are removed from the oven by the air which circulates in
the oven cavity. However, some steam will condense on cooler surfaces such
as the oven door. This is normal.
I accidentally operate my
microwave oven without
any food in it.
Operating the oven empty for a short time will not damage the oven.
However, we do not recommend this to be done.
There are humming and
clicking noises from my
oven when I cook by
Combination.
These noises occur as the oven automatically switches from microwave
power to Convection, to create the Combination setting. This is normal.
The oven has an odor and
generates smoke when
using the Convection,
Combination and Grill
function.
It is essential that your oven is wiped out regularly particularly after cooking
by Combination or Grill. Any fat and grease that builds up on the roof and
walls of the oven will begin to smoke if not cleaned.
The oven is not plugged in
securely.
Remove plug from outlet, wait
10 seconds and re-insert.
Circuit breaker or fuse is tripped or
blown.
Reset circuit breaker or replace
fuse.
There is a problem with the outlet. Plug another appliance into the
outlet to check if the outlet is
working.
The door is not closed completely.
Close the oven door securely.
Start Pad was not pressed after
programming.
Press Start Pad.
Another program has already been
entered into the oven.
Press Stop/Reset Pad to cancel
the previous program and
program again.
The program has not been entered
correctly.
Program again according to the
Operating Instructions.
Stop/Reset Pad has been pressed
accidentally.
Program oven again.
Timer/Clock Pad has been pressed
4 times.
Deactivate mode by pressing
Timer/Clock Pad 4 times.
The roller ring and oven bottom are
dirty.
Clean these parts according to
Care of Your Microwave Oven
(See next page).
NN-CD997S-HP_eng.indd 15 2007/09/10 13:25:55
To Next Page
Loading...
