To install pump motor
1. Insert pump motor into water tank holder.
2. Make sure that the pump motor is properly aligned after
installation.
NOTE:
To prevent tube B from slipping out after repairing,
make sure the insert depth should be proper when
inserting tube B into nozzle A.
4.8. Front cover
4.8.1. How to remove the fornt cover
1. Lightly twist the cover until the far side unclips.
2. Continue to twist until the near side unclips.
4.8.2. How to re-fitting the front cover
1. Align the slots on the cover with the holes on the tank.
2. Insert and push down until it clicks.
25
NN-CS894S
To Next Page
Loading...
