by the arrows with a cutter.
NOTE:
After breaking off the motor cover, make sure that cut-off portions
are properly trimmed off or bent to inside so that no sharp edges
will be exposed to the outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing 2 screw.
NOTE:
After reinstalling the new turntable motor and reconnecting the 2
lead wires, reinstall the motor cover by rotating it around 180°,
tucking the 2 tabs under the base into the 2 provided slots, then
screw the single tab to the base using a screw.
8.8. Quartz heater
1. Disconnect lead wires from heater terminals.
2. Remove 1 screw holding heater supports.
3. Remove the heater by pulling it out.
19
To Next Page
Loading...
