6.4. Fan motor
1. Disconnect 2 lead wires from fan motor terminals.
2. Remove 3 screws holding orifice assy and detach the orifice
assy from oven assy.
3. Remove fan blade from the motor shaft by pulling it straight
out.
4. Remove 2 screws holding fan motor on orifice assy and
detach the fan motor from orifice assy.
6.5. Door assembly
1. Support the door, remove 2 screws holding hinge A.
2. Open the door, remove door(U) and hinge A from cavity.
NOTE:
Support the door before opening.
3. Remove door C from door A (U) & door E by carefully
pulling outward starting from upper right hand corner using
a flat blade screwdriver.
4. Separate door E from tabs on door A (U) and remove door
A (U).
12
NN-ST340M / NN-ST340W / NN-SM330M / NN-SM330W / NN-SM320M
To Next Page
Loading...
