42
10.7. Replacement of FC Fan Motor
Warning: Make sure the unit is unplugged.
First you should open the multiflow cover as described at
previous sections
1. There are two housing at upper left corner in freezer com-
partment.
Left housing (bigger): For fan motor and defrost heater.
Right housing (smaller): For defrost sensor.
Note: Keep sealing material for re-sealing the con-
nectors after replacement.
2. Remove the sealing material (putty) at left housing. Then
pink and white connector can be seen in one housing.
Black leaded wires are connected with fan motor. Discon-
nect the fan motor connectors.
Note: To disconnect the connectors pull Them to the
down to release the tabs on connectors.
3. Cut both the black lead wires which comes from white
and pink color connectors. Faulty fan motor can be
removed from the multiflow cover.
Note: Cut the cables from a closer point to fan motor,
so you have longer cables when you connect the new
fan motor.
4. Remove the propeller by pulling forward.
5. Unscrew the two screws fixing the fan motor.
To Next Page
Loading...
