49
2. Cut off the cable tie ant remove the bitumen covering the
tubes.
Note: Keep bitumen for re-sealing the tubes after
replacement.
Warning: Before cutting the tube follow the Instruc-
tions of gas deflation, gas re-charging and welding
given at appendix and make sure the gas is evacu-
ated.
3. To take out the evaporator, tubes need to be cut with oxy-
gen welding.
Note: You need to protect the plastic cabinet from the
fire of welding with a protector as shown in the below
pictures.
4. Remove the evaporator by pulling forward in a horizontal
direction. Do not push it up or down. You may broke the
fixing plastics.
To Next Page
Loading...
