43
11.7. Disassembly of Compressor
Room
11.7.1. Pan Water EVA., Motor Protec-
tor, Cluster Block
1. Pan Water EVA
a. Pull Power Supply Code out.
b. Remove the six screws on Cover Panel Compres-
sor.
c. Pull and remove Cover Panel Compressor Assy
toward you from upper side.
d. Pull Pan Water EVA. toward you while pressing it
up.
NOTICE
• When you install Cover Panel Compressor Assy, set
the holes of the six screws firstly.
• Secondly adjust Cover PCB's position, and screw
the six screws.
2. Motor Protector
a. Insert a screwdriver (-) into the gap between Pro-
tector Cover and Compressor like the figure.
Pry off Protector Cover in a screwdriver (-).
Remove Protector Cover.
b. Take Motor Protector out from inside Protector
Cover.
3. Cluster Block
a. Pull Cluster Block out from Compressor like the
figure.
NOTICE
• Be careful not to twist when you pull Cluster Block
out or install.
To Next Page
Loading...
