Panasonic NS1000 - DECT CS Installation Process

5-0. DECT CS Installation (KX-NCP0158CE) – (1)
To assign a static IP Address to the KX-NCP0158CE IP-CS, the Panasonic UPCMC Tool is required. It is
not possible to set a static IP Address on the IP-CS via the NS1000 WebMC.
Step 1. Assign the IP-CS IP address, subnet, PBX IP address, . etc,
UPCMC Tool is required. (Available from your NSC)
Press next Select IP Terminal
Change DIP SW 7 to ON and
Power off/on the IP-CS.
Assign 192.168.2.xxx as PC
IP address and press next.
Assign IP-CS data like IP address, PBX IP address, etc.,
and press next. After that, Power off/on the IP-CS.
1 2 3
4 5
NB: By default, the KX-NCP0158CE is set to DHCP. It is only necessary to set a static IP Address if there is
no available DHCP Server or if the IP-CS is to be placed on a Network different than then PBX.