AC Cord Clip
Connect the other end of the AC
Cord to the UPS System
.
UPS System:
A UPS should be connected to the PBX to provide temporary in the event of a power failure.
When using the recommended UPS (APC RS Series with USB interface), the PBX can shutdown automatically by sending a warning signal to
the PBX through the USB port.
By shutting down correctly, data loss or serious damage to the PBX caused by a sudden power cut can be prevented.
When power is restored, turn off the PBX using the power switch first, and then turn the PBX back on before starting the PBX.
1.8 Connecting Power
Connecting the AC Cord
Using the AC Cord supplied with the unit, connect it to the PBX and secure with the supplied AC Cord Clip.
To Next Page
Loading...
