After installing the option cards, initialize the system (factory default settings)
1. Ensure the power switch is OFF.
2. Slide the System Mode Switch to the “SYSTEM INITIALIZE” position.
3. T
urn the power switch ON. (STATUS and MASTER LED will flash AMBER), the STATUS LED will the
n
flash GREEN.
4. Slide the System Mode Switch back to the “NORMAL” position. (When the STATUS LED is flashing.)
System Mode
Switch
Indicators
STATUS
BATT
ALARM
MASTER
5. When successfully executed, the STATUS indicator will
stop flashing and stay lit. (RED or GREEN)
Refer to Appendix for LED Sequence Detail.
2.1 System Initialisation
STATUS = RED (No DHCP)
STATUS = GREEN (DHCP)
MASTER = Flashing AMBER
(Master/Slave not assigned)
To Next Page
Loading...
