Set the unit
as Master or
Slave.
• If the Unit is to be configured as a Slave unit of a One-Look System on a Remote Site (Different Network than the Master), then set
the PBX Type as ‘Slave’ and enter the Master PBX IP Address in the Location Setting. (Master units in a One-Look system or Stand-
Alone units must be configured as a ‘Master’.
• It is important to select the correct Suffix/Country settings so that the correct default tones, emergency dial and other country
specific data are set automatically.
Set the unit Suffix Code
(UK, NE, CE, GR etc) and
your required country.
The Suffix Code can be
found on the units
Nameplate and box
Click ‘Next’ to
continue.
2.5 Easy Setup (1)
Location Setting
1.
S
et the unit status (Master/Slave), Suffix and Area
To Next Page
Loading...
