If ACTIVE is selected,
then the 60-day One-
Look Trial will start. If
NON-ACTIVE is selected,
it is possible to Activate
the Trial at a later date.
There are three terminal registration Modes;
Manual:
Suitable for all supported IP Terminals and network configurations.
Registration information is set manually in the Terminal and PBX.
(This is the recommended setting when a range of IP/SIP Terminals will
be used with the system.)
Full Automatic:
Suitable for UT/NT Terminals connected to the same network as the PBX.
All settings, including Extension Number are registered automatically.
NB: DHCP Server Required
Extension Number Input:
Suitable for NT Terminals connected to the same network as the PBX. All
network and registration settings are registered automatically. The
Extension number is configured manually via the Terminal.
NB: DHCP Server Required
2.5 Easy Setup (4)
LAN Setting
4.
E
nter the IP Terminal Registration Mode setting and select if ‘One-Look’ Trial should start.
Note:
1. Non-UT Series SIP Terminals must be registered manually.
2. By default, the UT-Series SIP Extension password is automatically set to ‘1234’
Click ‘Next’ to
continue.
To Next Page
Loading...
