Panasonic NV-DS29B - Error Codes and Troubleshooting

Hilnserting a Button-type Battery
Before using the Remote Controllar, insert the supplied button-type
battery.
1. While pressing the Stopper @, pull out the Battery
Holder. :
2. Insert the button-type battery with the imprint (+)
facing upward.
3 Insert the Battery Holder into the Remote Controller.
@When the button-type battery is weak, replace it with a new
CR2025 battery. (A battery is normally expected to last about 1
year. However, it depends on operation frequency.)
Make sure to match the poles correctly when inserting the battery.
WARNING
_ “THE LITHIUM BATTERY IS A CRITICAL COMPONENT (TYPE
NUMBER CR2025 MANUFACTURED BY PANASONIC).
IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT OR
DISCHARGE. IT MUST THEREFORE ONLY BE FITTED IN
EQUIPMENT DESIGNED SPECIFICALLY FOR ITS USE.
REPLACEMENT BATTERIES MUST BE OF THE SAME TYPE
AND MANUFACTURER.
THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION
AS THE ORIGINAL BATTERY, WITH THE CORRECT POLARITY
CONNECTIONS OBSERVED.
DO NOT ATTEMPT. TO RE-CHARGE THE OLD BATTERY OR RE-
USE IT FOR ANY OTHER PURPOSE. IT SHOULD BE DISPOSED
OF IN. WASTE PRODUCTS DESTINED FOR BURIAL RATHER
THAN INCINERATION.”
WUsing the Remote Controller
1 Direct the Remote Controller to the Remote Control
Sensor of the Movie Camera and press an
appropriate button.
Distance from the Movie Camera: Within secaxiaiatshy 5
metres
@ Angle: Within approximately 15° in the vertical and horizontal
directions from the central axis
The above operating ranges are for indoor use. Outdoors or under
strong light, the Movie Camera may not operate properly even
within the above ranges.
For other notes concerning this item, see page 42.
il