Panasonic NV-DS29B - Page 44

HiDigital Effect Functions
When you set the following functions, [EFFECT]
will be set to [OFF].
¢Progressive Photoshot Function
[PROGRESSIVE] (= 22)
© Digital Zoom [D.ZOOM] (> 23)
¢|mage Stabilizer Function [SIS] (- 24)
It is as follows when [GAINUP] is selected.
Manual Focus Mode
eThe shutter speed and White Balance cannot be
operated.
©The Sports Mode [ #& ], the Portrait Mode [8%
and Low Light Mode [g] are cancelled.
Picture-in-Picture Mode
lf the Movie Camera is turned off, the smaller
picture disappears.
The position of a small picture is fixed at the
bottom right of the screen.
Playing Back
Repeat Playback
If you continue to press the [>] Button for 5 seconds
or longer, the Movie Camera switches to Repeat
Playback Mode, and the [R >) Indication appears.
(To cancel Repeat Playback Mode, set the [VCR/
OFF/CAMERA] Switch to [OFF].)
Listening to Playback Sound through
Headphones
When you wish to listen to playback sound through
headphones, connect the headphones to the
[PHONES] Socket (- 9) on the Movie Camera. In
this case, no sound (including a warning sound and
shutter sound) will be reproduced through the built-
in speaker of the Movie Camera.
Multi-Picture Mode
@The quality of Multi images deteriorates slightly.
¢Playback Multi-Mode screens cannot be output
through the DV Terminal (-> 39) or Digital Still
Picture Terminal (+ 8).
lf there is input from DV Terminal, a multi screen
cannot be created.
i lndex Search Functions
Index Search may not be possible at the beginning
of tape.
Because Photoshot index Signals are not
recorded on still pictures recorded in Continuous
Photoshot Mode, the Photoshot Index Search
Function cannot be used for these still pictures.
Scene Index Search may not function properly if
the interval between 2 scene index signals is
shorter than 1 minute.
44
Playback Digital Effect Functions
@When [EFFECT1] on the [DiGITAL EFFECT] Sub-
Menu is set to [TRACER], the digital modes of
(EFFECT2] cannot be used.
® Signals of images.to which digital effects are
added during playback cannot be output from the
DV Terminal (+ 8) or Digital Still Picture Terminal
(> 39).
© Even if Playback Digital Zoom Functions are being
used, images that are output from the DV Terminal
(7 8) or Digital Still Picture Terminal (<> 39) are
not enlarged.
@ As you enlarge an image, the quality of image
suffers.
Wi Audio Dubbing
The blank section of a tape cannot be dubbed.
Sounds sent through the DV Terminal cannot be
dubbed.
If a tape has a non-recorded portion when the tape
is dubbed, images and sounds may be disturbed
when this portion of the tape is played back.
© If you set the tape counter back to 0 at the position
where you want to stop Audio Dubbing so as to
make it possible to use the Memory Stop Function
(7 51), Audio Dubbing is terminated automatically
when the tape reaches this position.
@In the case of importing data recorded with Audio
Dubbing to a PC using the PC’s software
programme, only the original sound (ST1) may be
imported, depending on the software programme.
WUsing the DV Cable for Recording
(Digital Dubbing)
@ Regardless of the setting, digital dubbing is carried
out automatically in the same audio recording
mode as that of the Cassette on the playback-side.
(NV-DS30 only)
©The images on the monitor of the recording side
may be disturbed, but it does not affect the
recorded images.
® Even if Playback Digital Effects or Playback Digital
Zoom Function have been used, these effects aro
not output from the DV Terminal.
Even if you use device equipped with DV
Terminals (such as IEEE1394), you may not be
able to perform Digital Dubbing in some cases.
®Do not connect both an S-Video Cable or AV
Cable and a DV Cable.