Panasonic NV-DS29B - Page 52

Hi Owner ID
You can register your name and address in your
Movie Camera to identify the owner.
1. Set [CAMERA FUNCTIONS] >> [OTHER
FUNCTIONS] >> [OWNER ID SET] >>
[ON].
@The [OWNER ID] Menu appears.
2 Turn the [PUSH] Dial to select
[PIN NUMBER] and press the [PUSH]
Dial to input desired numbers.
3 Turn the [PUSH] Dial to select numbers
and press the [PUSH] Dial to enter
them.
You can input 4 digits.
4 Press the [m] Button.
5 Repeat Steps 2-4 to input desired
characters for [NAME] and
[POSTCODE].
You can input up to 12 characters in [NAME],
and up to 11 characters in [POSTCODE].
6 Press the [m] Button to finish the setup.
To verify Owner ID
Keep pressing the [I] Button for
approximately 5 seconds.
To Check Owner ID
\f Owner ID has already been set, carrying out Step1
above wilt display [INPUT PIN NUMBER] on the
screen. Input the Pin Number you have already
selected. If the number is not correct, the screen will
not change. If the number is correct, the contents of
the setup will be displayed. (By repeating Steps 2 to
4 above, you can change the contents.)
Hi Demonstration Mode
If no operation takes place for approximately 10
minutes after the AC Adaptor was connected to the
Movie Camera and the [VCR/OFF/CAMERA] Switch
was turned to [CAMERA] without inserting a
Cassette, the Movie Camera is automatically set to
Demonstration Mode for introducing its functions. If
any button is pressed or operated, the
Demonstration Mode is cancelled. The
Demonstration Mode can be started by setting
{DEMO MODE] on the [OTHER FUNCTIONS] Sub-
Menu of the [CAMERA FUNCTIONS] Main-Menu to
[ON] and by exiting the Menu. To terminate the
Demonstration Mode, insert a Cassette or set the
[DEMO MODE] to [OFF].
52