Panasonic NV-F66A - Page 10

The adjustments described
on
this
page
are not necessary,
if the VTR
is connected to the TV
set via the Video/Audio
output sockets.
Video Playback
Channel Selector
This
switch is used to select the video
playback
channel
which
is not occupied
with any TV
station
(0
or 1).
@
tune tne
selected
programme position (Channel)
of
the TV
set to VHF channel 0
or
'1'.
Confirm on
your
TV
set that the received test
pattern
is
as shown.
'ln
some areas
channel0
may
be
used
by localTV
station. In
this case
switch to channel
1.
Set the Test
Signal Switch to
"Off".
Your TV is
now
readyto
receive the RF
output signalfrom the WR.
orrrlElrou
TEST
SIGNAL
To check,
play
back a
pre-recorded
tape
and confirm
picture
quality.
In
some cases, further
line tuning is required in
order
to
get
optimum
coiour and sound. Note that the
test signal
is
only a
guide.
o
o
o
o
oFF rl
Llllr
oN
TEST
SIGNAL
oo
Turn the TV set on and select
position
or another
programme
occupied by any TV station.
O
Press the VTR On/Off
Switch
to turn
the VTR On.
.The
corresponding indicator lights up.
Press the VTR/TV
Selector to
"VTR" position.
.VTR
Indicator will
appear in
the lvlulti-Function
Dis-
play.
Set the Test
Signal Switch to
"On".
orrfTjlrou
TEST
SIGNAL
the
AV
programme
position
that is not
o
@
(FBONT
SrDE)
VTR
tl
tl
(FRONT
StDE)
VTR/TV
r
(10)