Panasonic NV-F66A - Transmit the Programming Data; For Programming More Than One Timer Recording in Succession

Keep
pressing
the
Transmit Button and confirm that the
programmed
data on the Multi-Function Display
of
the VTR
are as desired.
After releasing the
button, the data will
continue to be
displayed tor about 12
seconds.
"Beep-beep-beep-beep-
beep..," sound indicates
programming
iS
completed.
.lf
the transmission
was not received
correctly, the
"Beep-Beep,
Beep-Beep"
sound
from
the VTR will warn
you.
In this case,
perform
transmission
again.
.The
transmission is
possible
when
lhe VTR is turned
on
but is not in
any of
the recording
or
playback
operation
modes.
lt is also
possible
when
the VTR is in the timer
recording standby mode
(E
indication is lit).
.The
programming
will be done
on
the
next lower
unoccu-
pied
timer
programme
number
(8-
1).
.lf
all
programme
numbers
are
occupied, the
"Beep-Beep,
Beep-Beep" sound from the
VTR will warn
you
that the
programming
cannot be made.
.When
the Transmit Button
is
pressed,
the
VTR will
automatically
be
put
into the timer recording
standby
condition
and the VTR will
be
turned
off.
.To
operate the VTR
before the timer
recording will
be
performed, press
the Timer Rec.
Button to
suspend the
timer recording
standby condition. After
using the VTR,
be
sure
to
press
the Timer Rec.
Button again, otherwise
the
timer recordino will
not be made.
After
programming
a timer
recording, the VTR
js
in the timer
recording
standby mode and
cannot be used for
any other
operation, such
as
playback.
lf some
other operation is
desired, first trace
the
"T|N4ER ON/OFF" bar
code and
transmit
it to the VTR with
the Transmit Button.
To later reset the
VTR to the timer
recording standby mode,
trace the
"Tll\4ER
ON/OFF" bar code aoain
and
transmit
it
with
the Transmit Button.
IlTfilFrir,fiittl
+_]llffill*
,,
Repeat the
lollowing operation steps
tO-
O.
Q
Trace the
"CANCEL"
bar code on the Programming
Sheet.
6@
H||lll+il-
o
o
Trace
the bar codes for
"CHANNEL".
"DATE".
"START
Tll\4E"
and
"END
TlME".
Confirm that the
present
time is
displayed on the
Multi-Functjon
Display of the VTR,
and
transmit the
data.
.lf
the next timer
programming
data are transmitted
while
the
previous
timer
programming
data are still
being displayed, the
displayed
timer
recording data
willbe cancelled.
It is
possible
to
programme
timer recordings
lrom
a unit
connected to the Audio
Input
Sockets and the Video
Input
Socket ol this VTR.
Set the Input Signal
Selector to "Line/Audio".
Trace
the
"AV"
bar code in the
"CHANNEL" column.
Note:
The
"AV
1"
and
"AV
2"
bar codes cannot
be used
with
this
VTR.
Hlltlullf-