Panasonic NV-GS90 - Connecting to Power Sources; Battery Safety and Handling

Before using
10
LSQT1291
ª Connecting to the AC outlet
The unit is in the standby condition when the AC
adaptor is connected. The primary circuit is
always “live” as long as the AC adaptor is
connected to an electrical outlet.
1 Connect the AC mains lead to the AC
adaptor and the AC mains socket.
2 Connect the DC input lead to the AC
adaptor.
3 Connect the DC input lead to this product.
≥Do not use the power cord for other
equipment since the power cord is exclusively
designed for the movie camera. Or do not use
the power cord of other equipment for the
movie camera.
ª
Fitting the battery
Push the battery against the battery holder and
slide it until it clicks.
ª
Removing the battery
While sliding the [BATTERY] lever, slide the
battery to remove it.
≥Hold the battery with your hand so it does not
fall.
≥Before removing the battery, be sure to set the
Mode dial to OFF and check that the status
indicator is off.
≥Do not heat or expose to flame.
≥Do not leave a battery pack in an automobile
exposed to direct sunlight for a long period of
time with doors and windows closed.
Notice about the rechargeable battery
The battery is designated recyclable.
Please follow your local recycling regulations.
1
2
3
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufacturer’s instructions.
Warning
Risk of fire, explosion and burns. Do not
disassemble, heat above 60 xC or
incinerate.
BATTERY
LSQT1291_ENG.book 10 ページ ２００８年３月５日 水曜日 午前９時４１分