Panasonic Omnivision PV-8200 - Page 13

If the displayed time is correct,
press CH A to exit.
¢ This concludes one time VCR setup.
+ See important note at the bottom of this page.
If the displayed time and DST. are not correct...
If you happen to live close to two time zones, the
VCR have recognized the PBS channel (setting
channel) in the wrong time zone. Please do the
following to correct the situation.
a Make a note of the SETTING:CH number shown
on-screen and press CH A to exit.
b Detete the setting channel from the VCR channel
memory. (See “To Add or Delete a Channel”
section on page 14.)
c Press ACTION to display the menu.
d Press AY to select “SET CLOCK,” and then
press © to display the “SET CLOCK” screen.
e Press AY to select “AUTO CLOCK SET,” and
then press P to display the “CLOCK AUTO SET”
screen.
f Press CH A to start Clock Auto Set.
* If you use a cable box and have multiple PBS stations,
tune the cable box to a diffarent PBS station and try
auto clock set using the menu.
if the screen above appears, auto clock set
is not available in your area. Please set the
clock manually as described below.
a Press ACTION to display
the “SET CLOCK” screen.
b Press AV and d >> to
select and set the month, eae Mey
date, year, time, and DST. END __JACTION KEY
(Daylight Saving Time). + See page 5 for more
on DST.
To Make Corrections,
repeatedly press {> to move the cursor to the
incorrect entry and make the correction.
c Press ACTION twice to
start the clock and exit
this mode.
SET :4 KEY
STAAT :ACTION KEY
SELECT/SET
(AVAD»)
keys
CHANNEL UP
IMPORTANT NOTE FOR AUTO
CLOCK SET
Auto clock set will be performed when
the VCR is turned off the first time each
day. If you use a cable box and you
want auto clock set to be performed, the
cable box must be left on and tuned to
the PBS channel before the VCR power
is turned off.
If you use a DSS receiver, it must be
tumed off for auto clock set.
If you use Audio/Video Jack connection
between the VCR and Cable Box or
DSS receiver, you must also connect
the RF coaxial cable in order to use the
auto clock set and channel auto set
features.
13
C)
O
=
5
Q
(PD .
re
ay
=
O
Q