Panasonic Omnivision PV-8200 - Page 15

I On-Screen Displays (OSD
Function & Channel Display
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
Menu Screen
1 Press ACTION to
display the menu.
2 Press AV and P to.
make
your
selection.
[END
ACTION
Key
SET UP CHANNEL
IO 1OMA/ LANGUE: ENGL | SH
SELECT:A Y KEY
SET :» KEY
+ To get the most from each feature,
please read the Operating Manual
before attempting any operation.
VCR Status & Clock Display
Press DISPLAY to display or remove the
overlay shown below.
Current Time
Channel
Function
Status
Counter
Tape Speed
(See page 5.)
Rec Time Remaining
{OTR mode only see page 17.)
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up in
Play mode, or when the selected channe! has no
broadcast signal with the Blue Back ON/OFF
Feature (page 26) set to ON, the TV screen will
turn solid blue.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
If no active channels are found
for CHANNEL MEMORY...
(See page 12.)
PUSH YCA CH UP KEY AGAIN
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 18.)
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCR OFF
f FOR TIMEA RECORDING
After a Timer Program has
been set...
(See page 18.)
if you press REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(See page 17.)
CHECK CASSETTE
RECORD TAB
If you press PLAY, FF, REW,
or REC on the remote
control or VCR without
a cassette inserted...
(See pages 16, 17.)
TO CANCEL TIMEA REC
PUSH POWER THEN STOP KEY
If you press POWER or STOP
during a Timer Recording...
(visible in VCR mode only) `
(See page 19.)
lf head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEAN
OR REFER TO MANUAL
END:PLAY KEY
If you press a function button
other than STOP/EJECT or
POWER while the VCR is in
VCR Lock mode... :
(See page 26.)
VCA LOCK ACTIVATED
if you press POWER, ACTION,
or PROG on the remote while
in TV or CABLE/DSS mode...
(See pages 24, 25.)
NOW TV/CABLE/DSS MODE
PLEASE PUSH YCA KEY
ON REMOTE
©)
D
=
=
te
y)
mp
&
=
+
D
o