Panasonic Omnivision PV-8200 - Page 20

kS Tape Operation
{Gur Vacation ||
*Important: If the remote control POWER, ACTION, PROG, CHA/¥ , INDEX, or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
VHS Index Search System
Each time you start a recording, an invisible index mark is automatically placed on the
tape. You can then use these index marks to access or scan your recordings.
Direct Access
This feature allows you to go directly to the recording you want from
anywhere on the tape by entering the appropriate index number.
1 Press INDEX* in Playback or
Stop mode.
REWIND FAST FORWARD 2 Press a NUMBERED key to
select the desired recording.
+ To calculate the number, see below.
3 Press REW or FF to start a INDEX SEARCH 04
reverse or forward search.
* When the designated location is reached,
the VCR goes into Playback mode.
REWIND
To calculate an index Number
Count forward or backward each recording start point, including
the recording you want to see, from wherever you are on the tape.
Example 1:
FAST If you are watching recording 4 and you want to watch recording 2,
FORWARD Count the start points to number 2. The total is 3. Enter 3 in step
3 “2” and press REW.
Example 2:
If you are watching recording 2 and you want to watch recording 6,
count the start points to number 6. The total is 4. Enter 4 in step
“2” and press FF.
NOTE: $ indicates start points of each recording.
e Make each entry within 10 seconds, or the Index Search mode will be canceled.
* Index marks will be placed for Timer recordings as well.
+ Ifthe VHS index Search System are initiated extremely close to an index mark, the index mark may not
- be counted in the search.