Panasonic Omnivision PV-8200 - Page 23

Leal a Copying Your Tapes (Dubbin
Connections you'll need to make.
e When connecting to a normal VCR, use the L Audio In jack for proper sound produi
Playing (Source) VCR Recording (Editing) VCR TV for Monitoring
1 inserta pre-recorded To Monitor Dubbing on Your TV * Bo
tape into the Playing
(Source)
VCR.
1
Tum
your
TV
on
and
tune
to
the
Recording
VCR channel (CH3 or CH4).
2 Set the VCR/TV Selector on the Recording
2 Insert a blank tape with VCR to “VCR.”
record tab into the
Recording (Editing) VCR.
Selecting the Input Mode
3 Select “LINE” Input mode on the Press INPUT.
Recording (Editing) VCR. (See “Selecting The display will change in the order below. =
the Input Mode” at right.) —, Channel ———» LINE e
( Number ) M
ot <
4 Press PLAY on the Playing VCR. or O
Press PAUSE at the desired starting point. Press CH A/V.
The display will change in the order below, O
ge a ae 1— F 3 3
5 Press REC on the Recording VCR, and then | ABLE) (TV) 0
press PAUSE immediately thereafter. NE 125 or 69 e)
6 Press PAUSE on both VCRs at the same
time, to begin copying.
+ When LINE is selected, “L” is displayed in the Multi
To Edit Out Unwanted Parts Function Display for about 4 seconds.
Press PAUSE on the recording VCR while copying is
in progress. Press PAUSE again to resume copying.
A OA A A + Unauthorized exchanging and/or
T Press STOP on both VCRs to stop copying. copying of copyrighted recordings
may be copyright infringement.
23