Panasonic Omnivision PV-8200 - Page 7

Between Antenna and VCR
Case 1: Twin Lead Cable Only
To VCR Terminal
—:
AA
(Flat) Twin Lead 300-75 ohm Transformer
300 Ohm Cable (not supplied)
Case 2: Twin Lead & Coaxial Cables
æt UHF/VHF
Band Mixer
: (not supplied)
(Round) 75 Ohm
coaxial
Cable
To
VCR
Terminal
Case 3: Two Twin Lead Cables
UHF/VHF
Band Mixer
300-75
ohm
(not
supplied)
Transformer
(not supplied)
To VCR Terminal
+ If your TV has both post and plug-type VHF
tarminals, the post connection is recommended to
minimize signal loss.
Between VCR and TV
Case 1: Screw & Plug Type Terminal
O
le)
3
3
D
O
=.
O
3
0
TV
UHF/VHF Band VHF
Separator
(not supplied)
RF Coaxial Cable
Case 2: Screw Type Terminal
75-300 ohm
Transformer
(not supplied)
TV
UHF/VHF Band VHF
Separator
(not supplied)
UHF
Case 4: Complex TV Terminal
TERMINALS ON BACK OF TV SET
ANT2
+ Connect to one of the ANT terminals and select the
same antenna number on the TV.