Panasonic Omnivision PV-8200 - Page 9

With a DSS Receiver
You can: IN FROM
CABLE or Antenna IN FROM
1) Record and view any channel including Satellite Dish OUTTO TV '
scrambled channels; channel selection
must be made at the DSS Receiver.
2) Program one channel tor unattended
recording.
NOTE: The DSS receiver must be turned off to
view programs from a cable box or
antenna. See the DSS manual for details.
VHF/UHF
“pss isa registered trademark of DIRECTV, INC., a unit of GM Hughed Electronics.
; . . If your TV has AUDIO IN and VIDEO IN terminats, you can connect your
Audio/Video Connections VCR to them to receive a higher quality picture and sound. If your TV is not
stereo, you can connect a stereo amplifier to the VCR to enjoy stereo sound.
Audio/Video Connections
IN FROM ANT
il
i ll |
fauno IN AUDIO OUT QS
1 Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV.
2 Connect the AUDIO OUT terminals on the VCR to the AUDIO IN terminals of your TV.
3 Set the VIDEO/TV selector of your TV (Monitor/Receiver) to “VIDEO.”
NOTE: To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO.”
Note to CABLE system installer:
This reminder is provided to call the CABLE system installer's attention to Article 820-40 of the NEC in USA (and to the
Canadian Electrical Code in Canada) that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
2
a]
=}
53
D
Y
=Œ
O
5
T