5.2.14. T Loading Arm Unit and S Loading
Arm Unit
5.2.14.1. Disassembly Procedure
1. Remove the T Loading Arm Unit by pulling it up while
releasing Locking Tab (K).
2. Pull up on the S Loading Arm Unit.
Fig. J13-1
5.2.14.2. Reassembly Notes
1. Alignment of Loading Rack Unit, T Loading Arm Unit,
and S Loading Arm Unit
a. Slide the Loading Rack Unit so that the holes on it and
the holes on the chassis line up properly.
b. Install the S Loading Arm Unit onto the Chassis.
c. Install the T Loading Arm Unit so that the triangle-
shaped indent is aligned with the arrow on the S
Loading Arm Unit as shown. Confirm that each hole on
the T Loading Arm Unit, Chassis, and Loading Rack
Unit are through holes.
Fig. J13-2
5.2.15. Center Clutch Unit, Changing Gear
Spring, Changing Gear, Changing
Lever-B, and Idler Arm Unit
5.2.15.1. Disassembly Procedure
1. Remove Cut Washer (B). Then remove the Center Clutch
Unit, Changing Gear Spring, and Changing Gear.
2. Remove Changing Lever -B so that the 2 Mounting Holes
clear Mounting Pins.
3. Pull up on the Idler Arm Unit.
Fig. J14-1
5.2.15.2. Reassembly Notes
1. Installation of Center Clutch Unit
a. Fit the Center Clutch Unit into the Changing Gear as
shown.
Fig. J14-2
2. Cut Washer (B) is not reusable. Install a new one.
32
PV-9661 / PV-9662
To Next Page
Loading...
