Panasonic Omnivision PV-9661 - Page 283

2. Installation of Holder Unit
a. Turn the Wiper Arm Unit so that the grooves on each
end are aligned with the each groove on Side Plate L
and R.
b. Insert Holder Unit boss (A) and (B) into the grooves
(See Fig. K1-1 on previous page).
c. Finally, in the EJECT Position, confirm that the
protrudence on the Wiper Arm Unit is aligned with the
indentation on the Drive Rack Unit.
Fig. K1-3
3. As an ESD countermeasure, make sure the spring is in
contact with Top Cover.
5.3.2. Sensor Cover, Opener Lever, and
Drive Rack Unit
5.3.2.1. Disassembly Procedure
1. Remove the Sensor Cover by releasing Locking Tab (D).
2. Remove the Opener Lever by releasing 2 Locking Tabs (E).
Then remove the Drive Rack Unit.
Fig. K2
34
PV-9661 / PV-9662