Panasonic Omnivision PV-C1321 User Manual

Important Safeguards and Precautions
[OUTDOOR ANTENNA INSTALLATION
READ AND RETAIN ALL SAFETY AND
OPERATING INSTRUCTIONS. HEED ALL
WARNINGS INTHE MANUAL AND ON UNIT =|
|____INSTALLATION
1 POWER SOURCE CAUTION
Gperate only from power source indicated on unit
or in this manual. if uncertain, have your Electric
Utility Service Company or Video Products Dealer
verify your home power source,
2 POWER CORD PLUG
For safety, this unit has a polarized type plug (one
wide blade), or a three-wire grounding type plug.
Always hold the plug firmly and make sure your
hands are dry when plugging in or unplugging the
AG power cord. Regularly temove dust, dirt, etc.
on the plug.
E ION: LARIZED PLUG ¢
The plug fit utlet one way. if it cannot be fully
| fits into o
inserted, try reversing it. If it still will not fit, have an
electrician install the proper wall outlet. Do not
tamper with the plug.
SROUNDING. PLU! TION:
The plug requires a three-hole grounding outtet.
If necessary, have ari electrician install the proper
outlet. Da not tamper with the plug.
3 POWER CORD
To. avoid unit malfunction, and to protect against
electrical shock, fire or. personal injury:
«Keep poser cord away from heating appliances
and, walking traffic. Do not rest heavy objects on,
or rolt such objects over the power cord.
- Do not tamper with the cord in any way.
- An extension cord should have the same type
plug (polarized or grounding) and must be
securely conneeted.
.» Overloaded wall outlets or extension cords is a
fire hazard. ;
+ Frayed cords, damaged plugs, and damaged or
cracked wire insulation are hazardous and should
be replaced by @ qualified electrician.
400 NOT BLOCK VENTILATION HOLES
Ventilation openings in the cabinet release heat
pena duririg operation. if blocked, heat
uild-up may result in a fire hazard or heat
damage to cassettes,
For yout protection:
a. Never caver ventilation slots while unit is ON,
or operate unit while placed on a bed, sofa,
rug, or other soft surface.
b. Avoid built-in installation, such as 4 book case
of rack, unless property ventilated.
5 AVOID EXTREMELY HOT LOCATIONS OR
SUDDEN TEMPERATURE CHANGES
Do not place unit over of near a heater or
regulator, in direct sunlight, etc. If unit is suddenly
moved from @ cold place to a warm place,
moisture may condense in unit and on the tape
causing damage.
6 TO AVOID PERSONAL INJURY
+ Never place unit on support or stand that is not
firm, jevel, and adequately strong.
The unit could fall causing serious
injury to a child or adult and
damage to the unit,
* Move any appliance and cart
combination with care.
Quick stops, excessive force, and
uneven surfaces may cause objects to overtum.
* Carefully follow all operating instructians.
2
1 SAFE ANTENNA AND CABLE CONNECTION
An outside antenna or cable systern. must be property
grounded fo provide some protection |
against built up static charges
and voltage. Section 810
of the Nationa! Electrical >
Codé, ANSINFPA 70 fin <ecoes
Canada, part 1 of the * datuadiaae
Canadian Electrical Code}
AC — mR, LETRA OE
provides information.
regarding proper grounding of tha mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location of
antenna discharge unit, connection to. grounding
electrodes, and requirements for the ee electrode.
2 KEEP ANTENNA CLEAR OF HIGH VOLTAGE
POWER LINES OR CIRCUITS
Locate an outside anterina system well away from power
lines and electric jight or power circuits so it will never
touch these power sources should it ever fall, When
installing antenna, absolutely never touch power tines,
circuits or other power sources as this could be fatal.
USING THE UNIT
Batore unit is bag otha storage or moved to a new location,
refer azine the INSTALLATION section of these safeguards.
1 KEEP UNIT WELL AWAY FROM WATER OR
MOISTURE, such as vases, sinks, tubs, etc.
2 IF EXPOSED TO RAIN, MOISTURE, OR
STRONG IMPACT, unpiug unit and have it inspected
cs a quate serviée technician betore use.
3 ELECTRICAL STORMS
During a lightning storm, or before leaving unit unused for
extended periods of time, disconnect all equipment from
the power source as well as the antenria and cable system.
4 WHEN UNIT IS PLUGGED IN
* DO NOT OPERATE IF:
- liquid has spilled into unit.
~ unit was dropped or otherwise damaged.
- unit emits smoke, malodors, or noises,
Immediately uriplug unit, ane have it inspected by a
nye poten oie and shock ah :
° Never or any openings in un
Tlticg bored Pray cause electric shock or firs hazard.
* Keap magnetic objects, such as speakers, away from
unit to avoid electrical interference.
5 USING ACCESSORIES
Use only accessories recommended by the manufacturer
to avoid risk of fire, shock, or other hazards.
6 CLEANING UNIT
Unplug unit. Usa 4 clean, dry, chemically untreated cloth to
gently remove dust or debris. DO NOT USE cleaning fluids,
aerosds, or forced air that could-over-spray, or seep into unit and
cause electrical shock. Any substanee, such as wax, adhesive
tape, etc. may mar the cabinet surface, Exposure te greasy,
humid, or dusty areas may adversely affect internal parts.
1 DO NOT SERVICE PRODUCT YOURSELF
lf, after carefully following detailed operating instructions, tha
unit does not operate property, do not attempt to open or
remove covers, or make any adjustments not described in the
tnanuat. Unplug unit and contact a qualified service tectinician.
2 REPLACEMENT OF PARTS
Make sure the service technician uses only parts specified
by the manufacturer, or have equal safety characteristics
a$ orginal parts. The use of unauthorized substitutes may
result in fire, electric shock, or other hazards.
3 SAFETY CHECK AFTER SERVICING
After unit is serviced or repaired, request that a through safety
check be done as described in the manufacturer's service
literature to insure video unit is in safe operating condition,

Panasonic Omnivision PV-C1321 Specifications

General

Brand	Panasonic
Model	Omnivision PV-C1321
Category	VCR
Language	English