Your Palmcorder may be connected to a
TV to play back tapes or to view what you
are recording.
_TV with AUDIO/VIDEO IN Jacks.
To Audio In
Audio/Video
Cable
(Supplied)
To Audio/Video Out
_TV without AUDIO/VIDEO IN Jacks.
To Audio _ _
RF Adaptor
! (°pti°nal) -I- VHF Antenna
I _,'11 300 ohm*7S ohm
| CH 3/4 Switch J_lt transformer
_or F Connector
/ _ UHF Antenna
vc rv
S e tor
VHFCo,,neoting_.-L_ I I
Cabte _ l II
To VHF Antenna __vO_L.___
Terminal
Before you begin...
• Connectthe Palmcorderto a power source.
Set the POWER switch to VCR to
playback a tape.
Or, set to CAMERA to view what your
Palmcorder is recording.
Turn the TV ON and set it to LINE
INPUT.
Check your "IV operating instructions
for further information.
Note:
If your TV has no VIDEO or AUDIO IN
Jacks, select CH 3 or 4 on your TV to match
the RF Adaptor CH 314switch and set the
VCRFFVselector on the RF Adaptor to VCR.
Start playback or begin a recording.
If you have connected the Palmcorder
to your TV using an RF Adaptor:
Set the POWER switch to OFF on the
Palmcorder,
Then, set the VCR/TV Selector on
the RF Adaptor to TM.
Now, turn the TV ON and select a
channel.
"CATV System Installer
This reminder is provided to caU the
CATV system inslaller's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
25
To Next Page
Loading...
