Charge the Battery Pack fully
before operation.
POWER
Lamp
CHARGE
Lamp
Plug in the AC Adaptor.
POWER Lamp lights up.
Insert the Battery
_) Align the right side of the Battery
with the line on the AC Adaptor.
(_ Press down on the Battery and then
slide it in the direction of the arrow.
CHARGE Lamp lights up. It goes out
when charging is done (about one and
a halt hours).
Remove the Battery
Slide the Battery out and then lift up.
Note:
• The useful operation time of the Battery will
After recharging the Battery Pack about 5 times, gradually decrease after repeated use and
use the BATTERY REFRESH feature as
recharging. The Battery is no longer
exptained on page 8. serviceable if the operation time is very ShOrt,
even after a sufficient charge.
With a fully charged Battery Pack, you will have a maximum of about one and a half
hours of continuous use. (If the Built-in Light is used, battery operating time decreases,)
Attach the Battery
(_) Align the Battery with the top of the
mounling surface.
_) Press it into place until it locks with a
click.
€)
d_# Remove the Battery
While sliding the BATTERY RELEASE
bu_on, remove the Battery.
7
To Next Page
Loading...
