DC Power Cable _/._
POWER Lamp DC IN ] Connect the VCR DC OUT on
ector the AC Adaptor to the DC IN on
the Palmcorder with the DC
Power Cable (supplied).
• The POWER Lamp wilt light up.
Note:
• AG Adaptor can not be used to power the Palmcorder while charging the IBattery.
, While not in use, unplug the AC Adaptor from the AC outlet. (AC Adaptor consumes
1.2W of electric power it it is plugged into an AC outlet even when not in use.)
Connect a PV-C16 Car Battery Cord
Cigarette Lighter
DO IN
Connector
Car Battery Cord Cigarette
(optional) Lighter Plug
(optional) to the DO IN of the
Patmcorder.
Start your car engine _ insert
the Car Battery Cord plug into your
cigarette lighter socket.
• There is a fuse rocated in the Iighter plug
end of the cord.
Should fuse repl,_cement be necessary
use the exact current rating (in amps).
Note:
* This cord can only be used in vehicles
equipped with DC 12V (negative ground)
batteries. Use only the specified car battery
cord. If you are not sure check with your local
car/truck dealer as to what type of DC battery
ground you have in your vehicte.
- Be sure to start your car engine before
inserting the cigarette lighter plug of the
Car Battery Cord into the lighter socket;
otherwise, the cigarette lighter plug fuse
may burn out.
• Because the car is running while your
Paimcorder is in operation, make sure
you're in a well ventilated area.
• Disconnect the cigarette lighter plug when
your Palmcorder is not being used.
9
To Next Page
Loading...
