Youl Palm_urder _LJ_ybe uolJl_ucted to a TV to play
back tapes or to monitor what you are recording.
_TV with AUDIO/VIDEO IN Jacks.
Audio/Video
Cable
(Supplied)
_o Audio/Video Out_
_TV without AUDIO/VIDEO IN Jacks._
Connect your Palmcorder to a powersource (Battery Pack, AC Adaptor or
Car Battery cord).
POWER
2
VCR CAMERA
Set the POWER switch to VCR to
playback a tape.
Or, set to CAMERA to monitor what your
Palmcorder is recording.
Turn the TV ON and set it to LINE
INPUT.
Check your TV operating instructions
for further information.
Note:
If your TV has no VIDEO or AUDIO IN
Jacks, select CH 3 or 4 on your TV to match
the RF Adaptor CH 3/4 switch and set the
VCR/TV selector on the RF Adaptor to VCR
Start playback or begin a recording.
_To Audio/Video Out_
RF Adaptor_ T_HF Antenna_
optional) _)
CH 3/4 Switch _i_] I 300ohm-75ohm
-_V transformer
(not supplied)
or F Connector
I UHF Antenna
VHF.Connecting II --"__ _
Cable _ _1 ['_Back of TV/L
(not supplied)
(_O VHF Antenna"_
_,,.Terminal j) I
This feature allows you to remove all
Electronic Viewfinder Indications.
Before inserting a tape, press DISPLAY
and STOP together for more than one
second to remove the indications except
time and date*.
To display the Electronic Viewfinder
Indications again, turn the Palmcorder
Power off and then again on.
*To remove the time and date, refer to
page 13.
If you have connected the Palmco=der to
your TV using an RF Adaptor:
POWER
OFF
VCR CAMERA
Set the POWER switch to OFF on the
Palmcorder.
*Then, set the VCR/TV Selector on
the RF Adaptor to TV.
Now, turn the TV ON and select a
channel.
21
To Next Page
Loading...
