Panasonic Palmcorder IQ PV-IQ604 - Copying your Tapes (dubbing); Main Operation; Monitor with your TV

Before you begin...
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER switch to VCR.
1[Ic°nnecti°nTo
TVit ° VHF Connecting Cable
(not supplied)
- Recording: "_
o o o VCR |
/
In Audio
Audio/Video Cable
(supplied)
Audio Out
Palmcorder
1
Insert a pre-recorded tape
into the source (playing) Palmcorder and a
blank tape with record tab into the editing
(recording) unit.
Press PLAY on the (playing) Palmcorder.
Press STILL when the tape reaches the
point you want to start dubbing.
40I_+EI
Press PLAY and REC together then
immediately press STILL on the
recording unit.
5@+ID
Press STILL on the playing Palmcorder
and PAUSE/STILL on the recording unit to
begin copying your tape.
Press STOP on both units when dubbing
is complete.
DC Input
Connector Video Out_
E)CPower
ocou/,_u, J []
Connector To AC Outlet
28
° Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
IuCAUTION:
r
nauthorized exchanging and/or copying ofI
opyrighted recordings may be copyright
I
nfringement.