Panasonic Palmcorder PalmSight PV-L557 - Copying your Tapes (dubbing); Main Dubbing Operation; TV Monitoring During Dubbing

Copying your Tapes (dubbing) |
Main Operation
Before you begin...
* Connect the Palmcorder to VCR as shown 1 Insert a pre-recorded tape
below. .
; to the Palmcorder and a blank
* Turn ON both units. n : : :
* Set the recording VCR's input Signal VER with a recording tab into your
Selector to LINE.
* Set the Palmcorder POWER
switch to VCR. 2 Press PLAY on the Palmcorder and
when you find the starting point, press
STILL.
3 Press PLAY and REC together on
. your VCR and then immediately
Source
(Playing)
press
STILL/PAUSE.
Palmcorder
PAUSE/STILL STOP REW PLAY FF REC
VCR Buttons
Z sss STILL on the Palmcorder
and press STILL/PAUSE on the
VCR to simultaneously start both
units.
Audio/Video Out
(To View)
Audio/Video Cable
(supplied)
VHF Connecting Cable 5 Press STOP on both units
(not supplied) when dubbing is complete.
Recording:
Note:
* Tapes recorded on other VCRs and used
for playback in the Palmcorder must be
To Video In recorded in SP or SLP mode.
Monitor with your TV g eee cda dubbing a tape may
* Turn the TV ON and select its VCR
channel (CH3 or CH4), CAUTION:
Unauthorized exchanging and/or copying of
* Set the VCR/TV Selector on the : : j
copyrighted recordin be copyright
recording VCR to VCR. a e e AA
32