Panasonic Palmcorder Palmsight PV-L559 - Page 40

Security Mode
Motion Security may mistakenly start
when:
* background is plain, like a white wall, or
has distinct vertical, horizontal, or slanted
stripes, like a venetian blind,
° brightness suddenly changes.
Motion Security may not start when:
* motion is very slow or fast.
* moving object is very small.
* motion occurs only in 1 corner of viewing
area.
* in poor lighting (in this case, MOTION
SECURITY flashes).
* background is plain, like a white wall, or
has distinct horizontal or vertical stripes.
Note:
e Security recording starts if Camcorder is
bumped or repositioned.
¢ This feature is not available during normal
recording.
» While in Security stand-by, the
following functions are not avaitable:
Record/Pause, Stand-by mode, Digital
E.1.S., Time Lapse, Auto Fade, Digital
Fade.
40
Before you begin...
» Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
e Insert cassette with record tab (page 13).
e Set POWER to CAMERA.
» Securely position and aim Camcorder.
1 Press MENU for MENU mode.
Press UP A or DOWN Y to select
SECURITYR
A PAGE 2/2
TIME LAPSE ; OFF
; OFF
VÍDEO EFFECTS ; FADE
BLACK
SELECT: PUSH V/A KEY
SET : PUSH DISPLAY KEY)
ENO : PUSH MENU KEY
2 Press DISPLAY for SECURITY
menu. Press DOWN Y to select
CO . Press DISPLAY to
confirm entry.
--- SECURITY MODE ---
OFF
MOTION
SELECT: PUSH Via KEY
SET : PUSH DISPLAY KEY;
3 Press MENU for Motion Security
stand-by mode. (If cassette
is not inserted, “[g3)” will flash.)
MOTION MOTION
SECURITY
SECURITY
STAND-BY
+ Recording will start about 3 seconds
after motion is detected.
* Date and time are recorded if
displayed in EVF (page 19).
* Recording stops 30 seconds after
motion ceases.
To cancel Security Mode, set POWER to
OFF.
For assistance, call 1-800-211-PANA(7262)