Panasonic Palmcorder PalmSight PV-L658 - Supplying Power

Supplying Power
Charge the Battery Pack ()
Charge the Battery Pack fully 2
before operation. 5
le
o)
rm
re)
ms
POWER
E
Lamp
1 Plug in the AC Adaptor.
POWER Lamp lights.
Insert the Battery
® Align the right side of the Battery with
the line on the AC Adaptor.
(B) Press the Battery down and slide it in
the direction of the arrow.
CHARGE Lamp lights. When charging is
done (about one and a half hours) the
lamp goes out.
Remove the Battery
Slide the Battery out and lift up.
Note:
After recharging the Battery Pack about 5 times, ° The useful operation time of the Battery will
use the BATTERY REFRESH feature as gradually decrease after repeated use and
recharging. The Battery is no longer
serviceable if the operation time is very short,
even after a sufficient charge.
explained on page 10.
Use the Battery Pack
With a fully charged Battery Pack, you will have a maximum of about 2 hours of continu-
ous use (LCD monitor is off) or about 1 hour of continuous use (LCD monitor is on). (The
actual operating time may vary due to operation conditions. If the Built-in Light is used,
battery operating time decreases.)
1 Attach the Battery
® Align the Battery with the top of the
mounting surface.
® Press it into place until it locks with a
click.
BATTERY 92
PACK Remove the Battery
While sliding the BATTERY RELEASE
button, remove the Battery.
9